List of Sponsored Projects

Sponsored Projects 2017 - 2018

S. No. Name of the Project Year of sanction Funding Agency Project Cost (Rs in Lacs) Principal Investigator
1 On Developing Reliable Scale-up Procedures and Design Optimization for Pneumatic Fly Ash Conveying Systems for 500/800/1000 MW Units 2018 NTPC 115

Dr. S.S.Mallick (PI),
Dr. Anu Mittal (Co-PI)
Dr. Gautam Setia (Co-PI)
Atul Sharma (Co-PI) 

2 Design and Development of a Three-Link Rigid-Flexible Manipulator for High Speed Operations 2018 DST-SERB 64.1212 Dr. A. Singla,
Dr. T. K. Bera
Dr. SK Saha
Dr. SP Singh
3 Development of electron beam cured carbon fiber/epoxy laminate filled with carbon nano tubes for mechanical joints 2017 DST-SERB 29.11 Dr. J S Saini, Dr. H. Bhunia
4 Development of Microwave Processed Cavitation Erosion Resistant Cladding 2017 DST-SERB 17.16

Dr. Dheeraj Gupta (PI) 

Dr. Vivek Jain (Co-PI)

5 Computational and experimental study of flow-induced vibration of a plate with piezoelectric material to improve performance of wind vibration energy harvester 2017 DST-SERB 24 Dr. Ashish Purohit

Ongoing Sponsored Projects

S. No. Name of the Project Year of sanction Funding Agency Project Cost (Rs in Lacs) Principal Investigator
1 Reforming of biogas for hydrogen production and its utilization in CI engine under dual fuel mode September 2016 MNRE 38.95 Dr Amit Dhir (PI) Dr. S. K. Mohapatra (Co-PI)
2 Experimental Investigation and CFD modelling of slurry pipeline for flow of multiparticulate slurry at higher concentrations March 2016 DST-SERB 37.09 Dr. Satish Kumar (PI) Dr. S. K. Mohapatra (Co-PI)
3 Design and Development of a Novel Honing Type Magnetorheological Finishing Process. 2016 DST-SERB 29.69 Dr. Anant Kumar Singh
4 Theoretical Modeling and Experimental Investigation of Nanofluid-Based Volumetric Absorption Concentrating Solar Collector July 2016 SERB 25 Dr. Vikrant Khullar
5 Structural response characteristics of CNT reinforced multilayered composite and sandwich plates in hygro-thermal environment 2016 DST-SERB 18.972 Dr. Neeraj Grover
6 DST-FIST March 2016 DST-FIST 1.02 Dr. S. K. Mohapatra
7 Improvement of part quality by controlling Shrinkage and Surface Roughness in 3D Printing 2015 Thapar Institute of Engineering & Technology 5.00 Dr. Vineet Srivastava
8 Improvement of part quality by controlling Shrinkage and Surface Roughness in 3D Printing 2014 DST 13.36 Dr. Madhup K Mittal
9 “Simulation and Analysis of Flow Through Microchannels Fabricated Using Ultrasonic Micro-Machining” 2013 Thapar Institute of Engineering & Technology 5.00 Dr. Vivek Jain
10 Development of Metallic Nano-Composite Cladding on Poor Tribo Characteristics Metallic Substrate through Microwave Heating 2013 Thapar Institute of Engineering & Technology 5.00 Dr. Dheeraj Gupta